Hello List I was not too happy with the drill sizes and pads of some components and found a solution in the archives by using the command line entry. Problem 1 : The drag down box does not show me the available commands Problem 2 : The following command did not seem to have any effect: >> :ChangeDrillSize selectedpins =43 mil
As reported earlier , i also have problems using the shift-left-mouse-click to replace components. My PCB crashes. Could the be related to install problems ? grtz Simon ----- Original Message ---- From: Steve Meier <[EMAIL PROTECTED]> To: gEDA user mailing list <geda-user@moria.seul.org> Sent: Sunday, 26 August, 2007 3:36:06 PM Subject: Re: gEDA-user: novice enquiry gschem is suitable for most schematics, it does have limitations in certain advanced usages. Steve Meier DJ Delorie wrote: >> Is gschem suitable? >> > > Yes. > > >> If so, how do I go about downloading it? >> > > http://www.geda.seul.org/download.html > > > _______________________________________________ > geda-user mailing list > geda-user@moria.seul.org > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user > > _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user ___________________________________________________________ Want ideas for reducing your carbon footprint? Visit Yahoo! For Good http://uk.promotions.yahoo.com/forgood/environment.html _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user