On Mon, Dec 03, 2007 at 10:07:23AM -0800, Lope De Vega wrote: > I'm trying to build a circuit with a cp2102, which has > 0.5 mm between pins' center (actually 0.2mm between > pins). It is a qfn-28 package.
Same spacing as QFP, which I've done successfully. I didn't try to toner-transfer it, though! I did have my soldermask ganged by the manufacturer but I was still able to put down a 208 pin QFP without bridges, just using lots of flux. I'm not sure how a home-etch board would fare. FT232R would be easier to put down, I think. -- Ben Jackson AD7GD <[EMAIL PROTECTED]> http://www.ben.com/ _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user