On Sun, 2007-12-09 at 10:38 -0600, Martin Maney wrote: > On Sat, Dec 08, 2007 at 10:12:45AM -0800, Harry Eaton wrote: > > Actually this is simply that you have the layer named > > "component" on the solder side and the layer named > > "solder" on the component side. That's a really bad > > way > > to set up the layer groups. > > Yes, that seems logical. As best I recall *I* didn't do any setup of > the layers - that was how PCB had them by default. So of course I > never thought to check that.
PCB and gsch2pcb both provide default layer groupings. It depends on which you started your layout with, which you'll get. I really hope neither of these is setting the component and solder stackup wrong! > That's interesting - it's in ~/.pcb/preferences, and it does seem to > be different than what it sets up de novo, but I have no memory of > intentionally changing groups, either through the GUI or by editing > preferences (well, until I edited it just now to put it back to sane). > Speaking of the layers/groups GUI, I stumbled across that once upon a > time, but now I can't find it. Hints? File->Preferences Layers option on left, Groups tab on the right pane. > Thanks! > -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user