On Fri, 2008-01-04 at 20:19 -0500, Paul Tan wrote: > Hi Steve, > > I am not using that feature currently, but its a nice feature and I > might > use the post-backend feature in the future.
Tangentially related.... To fix the spice-sdb slotting feature (patches not committed yet, but awaiting comments), I had to explicitly split gnetlist.scm into two parts. I moved gnetlist.scm and the netlist backend to load BEFORE traversing the board, and have gnetlist-post.scm run AFTER. This is because I introduced (propose to introduce) a scheme hook for determining the UREF of a component. This is determined during schematic traversal time, so at this point, the backend must have loaded. However.. gnetlist.scm also has some (define ...) code which is evaluated as soon as gnetlist.scm is loaded, and MUST NOT be run until after traveral. (This was the bit I moved to gnetlist-post.scm). -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user