Thanks for reply. I have converted my design, however naming nets is more problematic than those bus connection symbols, mostly because of placement of the text. With \_ symbol netname= attribute is always near bus (where I want it), with nets it is not. I red that that buses are new - is this the final way of handling them or are there any planned changes? I did not say that the current way is bad, just wanted to know.
Best Regards, Michael W. Dnia 4 maja 2008 15:32 Ales Hvezda <[EMAIL PROTECTED]> napisaĆ(a): > > >> Hello, > >> I have created a schematic with buses on it, however after drc I found > >> that > > buses are not connected. > >> When I connect a net to a bus gschem draws a nice bus connection symbol > >> (lo > >oks like \_). I added a netname=something attribute to these symbols to > >connec > >t right pins but it seems that they were ignored. What I have done wrong? Or > >m > >aybe I should ask: what is an official way of using buses in gschem? > > > >The bus is only graphical. You need to have a named net at each end of > >a connection. > > > > ... by putting the netname= attribute on the net instead of the > bus junction \_ symbol. > > -Ales > > > > _______________________________________________ > geda-user mailing list > geda-user@moria.seul.org > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user > _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user