On Tue, Jun 3, 2008 at 10:19 AM, John Luciani <[EMAIL PROTECTED]> wrote:
> I am assuming you want low values of resistance and capacitance. > What kind of tolerances do you require? For a cap you could create a > footprint > with parallel pads on the component and solder sides. > For resistances create a footprint consisting of a series of overlapping > pads. Can you _control_ those values? I'm assuming the typical process involves specifying a value, and there's a way to make the board to spec. -- Timothy Normand Miller http://www.cse.ohio-state.edu/~millerti Open Graphics Project _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user