>> ------------------------------ >> > Message: 6 > Date: Wed, 23 Jul 2008 15:51:12 +0100 > From: Peter Clifton <[EMAIL PROTECTED]> > Subject: Re: gEDA-user: geda-user Digest, Vol 26, Issue 47 > To: gEDA user mailing list <geda-user@moria.seul.org> > Message-ID: <[EMAIL PROTECTED]> > Content-Type: text/plain > > On Wed, 2008-07-23 at 14:49 -0400, Vincent Onelli wrote: > >> Thank you so mutch, this works >> Here is another question, can I setup board size width and hight >> larger than is need and then draw an outline for the proper size >> required? This >> will accomodate any shape board >> Thank you again. Vinny > > Yes, just rename one of the layers "outline" (or add it as a new layer), > and the right thing will happen. > > -- > Peter Clifton > > Electrical Engineering Division, > Engineering Department, > University of Cambridge, > 9, JJ Thomson Avenue, > Cambridge > CB3 0FA > > Tel: +44 (0)7729 980173 - (No signal in the lab!) > Thank you > > > ------------------------------
_______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user