Hey all, I'm having a problem with a the frontmask gerber file. The fabhouse put a hold on the order as there was according to them a problem with an undefined D code in the top-soldermask. When I looked at this in gerbv I noticed a similar error : this:
Errors found in Gerber file(s): Layer 5: ERROR: Found aperture out of bounds while parsing G code: 0 but the G Codes section shows this: G code statistics G0 = 0 (Move) G1 = 10 (1X linear interpolation) G2 = 0 (CW interpolation) G3 = 10 (CCW interpolation) G4 = 14 (Ignore block) G10 = 0 (10X linear interpolation) G11 = 0 (0.1X linear interpolation) G12 = 0 (0.01X linear interpolation) G36 = 81 (Poly fill on) G37 = 81 (Poly fill off) G54 = 93 (Tool prepare) G55 = 0 (Flash prepare) G70 = 0 (Units = inches) G71 = 0 (Units = mm) G74 = 0 (Disable 360 circ. interpolation) G75 = 10 (Enable 360 circ. interpolation) G90 = 0 (Absolute units) G91 = 0 (Incremental units) Unknown G codes = 0 I am somewhat new to actually fabbing boards so I'm not sure what the deal is here. I am generating the gerber files from PCB and the PCB is definitely not placing any elements out of bounds. Are there some settings I should be looking at on PCB and is there a way to fix this without actually changing the layout but only fixing layer 5 or the frontmask in this case? Thanks! Idan Beck
_______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user