My mental picture was that if I select a block from gschem and paste it into pcb that the correct land patterns and the netlist between pins of those land patterns should "walla" "appear" in pcb.
This is of course "futuristic"! But shouldn't the design of a cut and paste operation be forward looking? Steve Meier On Fri, 2009-01-16 at 19:46 -0700, John Doty wrote: > On Jan 16, 2009, at 7:40 PM, Steve Meier wrote: > > > footprintSSSS and netlist > > gschem (correctly IMNSHO) doesn't even know what these are, as they > depend on which flow you're using. > > "A program should do one thing well". Netlisting and layout are not > the charter of a schematic capture program. > > > > > > On Fri, 2009-01-16 at 18:22 -0500, DJ Delorie wrote: > >> It would be really cool if you could cut/copy in gschem, and paste in > >> *pcb*, and have the right footprint show up. > >> > >> > >> _______________________________________________ > >> geda-user mailing list > >> geda-user@moria.seul.org > >> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user > > > > > > > > _______________________________________________ > > geda-user mailing list > > geda-user@moria.seul.org > > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user > > > > John Doty Noqsi Aerospace, Ltd. > http://www.noqsi.com/ > j...@noqsi.com > > > > > _______________________________________________ > geda-user mailing list > geda-user@moria.seul.org > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user