On Wed, 2009-02-18 at 15:18 +0100, Denis Grelich wrote: > I have set the fullpoly flag manually, which wasn't a big deal since I > had to do a lot of manual work in the file (especially when it comes to > arcs -- I was even thinking about writing a patch to be able to work > with arcs sensibly with the GUI, maybe I'll still look into it even > though the board is finished.) > Without fullpoly, I wouldn't get the plane filled with GND, but only > some small isle.
Seemed to work for me just now when I tried it. You just loose some islanded sections. The code is supposed to keep the largest piece of the polygon. Sometimes this works fine. other times.. you want to re-connect the islanded pieces, so it becomes a pain to have to redraw them. You'll just have to beware of the connectivity checking failures with "fullpoly" for now. -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user