On Wed, Apr 1, 2009 at 7:43 PM, Darrell Harmon <dlhar...@dlharmon.com> wrote: > I recently ordered a batch of 4 layer boards from 66each and was able > to get 7 different boards on the panel. I made a router table from my > Dremel tool from MDF and used an 0.031" carbide end mill set to cut > about half way through the board. After routing both sides, the edges > I routed are hard to tell from the ones Advanced Circuits routed. The > FR4 dust was bad, so you may want to wear a mask if you do it this > way.
Do you have a picture of your setup? Any idea how many linear inches you get per end mill? (* jcl *) -- You can't create open hardware with closed EDA tools. http://www.luciani.org _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user