> Your board looks nice, as always. Thanks!
> I was told to avoid 90 degree angles in traces, it was something about > impedance or EMI, IIRC. The one case I saw where someone actually built two boards, one each way, and tested - it made no difference. Besides, at these scales, the rounded corners PCB uses are probably as effective as arcs anyway. > You do not expect some EMI problems or high impedance from the 90 degree > cornered angles ? For this board, I don't care about radiated EMI. I'm not even sure I could *etch* a real 90 degree corner in my basement, anyway. > Report(SelectedNetLengths) comes to mind (may be, or may be not > implemented yet). Not implemented yet. The syntax allows for a unit after the command, like "Report(AllNetLengths,mm)" and I was thinking of allowing a regex after that, or the key words "selected" or "found". _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user