On May 20, 2009, at 7:07 PM, Peter Gregson wrote: > > I am having considerable difficulty installing geda-bundle on my > MacBook running Mac OS X 10.5.7. I tried fink; it appeared to work > after much messing about caused by my version of fink not > updating the > table when it says that it has. I have tried using Fink and > FinkCommander, without success. Then I tried downloading from the > sources download page and running make. That showed me that I > needed > guile. After hours scanning the web, I found a forum where someone > had a similar problem and suggested installing gmp and guile from > [1]http://rudix.org. I did that and the compile went further but > aborted with some _scm_xxxxx symbols undefined. I gave up in > frustration. > > Trying again tonight, I booted the computer and this time > FinkCommander told me that geda-bundle was not installed. I tried > again to use FinkCommander to load the geda-bundle binary. This > time, > it appeared to load properly as shown below. > > Selecting previously deselected package geda-gschem. > Unpacking geda-gschem (from > .../geda-gschem_1%3a1.2.1-10_darwin-i386.deb) ... > Selecting previously deselected package geda-gsymcheck. > Unpacking geda-gsymcheck (from > .../geda-gsymcheck_1%3a1.2.1-11_darwin-i386.deb) ... > Selecting previously deselected package geda-bundle. > Unpacking geda-bundle (from > .../geda-bundle_1%3a1.2.1-10_darwin-i386.deb) ... > Setting up libgeda31-data (1.2.1-11) ... > Installing new version of config file /sw/etc/gEDA/system-gafrc ... > Setting up libgeda31-shlibs (1.2.1-11) ... > Setting up geda-gattrib (1.2.1-10) ... > Setting up geda-gnetlist (1.2.1-11) ... > Setting up geda-gsch2pcb (1.2.1-11) ... > Setting up geda-utils (1.2.1-11) ... > Setting up geda-gschem (1.2.1-10) ... > Setting up geda-gsymcheck (1.2.1-11) ... > Setting up geda-bundle (1.2.1-10) ... > > Now, when I try to run gschem, I get: > > Failed to load default component libraries. > Pango-ERROR **: file pango-layout.c: line 3189 > (pango_layout_check_lines): assertion failed: (!layout->log_attrs) > aborting... > Abort trap > How do I solve this? >
If you have the debris from a source install still hanging around, you'll often have problems. Be sure you remove them. John Doty Noqsi Aerospace, Ltd. http://www.noqsi.com/ j...@noqsi.com _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user