On Sat, 2009-06-20 at 17:27 +0000, Kai-Martin Knaak wrote: > Just came across two minor postscript issues: > > * The index page talks about "top"/"bottom", but the files are named with > "front"/"back". Pcb should stick to one layer name pattern. I'd very much > prefer top/bottom, as all the fabs I worked with seem to use this scheme.
ACK, that would be good. > * Peter Cliftons "after pours" version of pcb the produces assembly > prints in $NAME_front.ps and $NAME_back.ps if the multifile is chosen. > That is, these files contain copper plus silk, rather than copper only. > This my be related: Without the multifile option there are an additional > two, empty pages in the document. Yes - I broke something somewhere in my tree, and haven't had chance to go hunting for it yet. -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user