On Sat, 2009-11-14 at 13:09 -0800, John Eaton wrote: > However it is in your best interest to specify exactly how you want > them routed, and/or scored, > by known you Contract Assemblers needs. > > ------------------------------------------------ > Do not let your board house tell you that their router bit is 1/8" and > make that > your image separation. They want to do it in a single pass.Their > router may > start out 1/8" when new but as it wears your board edge creeps. > Make your image separation a little more than the router bit width so > that they have > to make two passes. Then both edges will be controlled by the bit > position and not by > the bit width.
Assuming they offset the cut by the _actual_ width of the router bit, rather than its nominal width. _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user