On Mon, 2010-03-08 at 13:30 -0500, Jim wrote: > Are there any fab shops that would be gentle with a very new, very > inexperienced PCB designer? OH and reasonable for a prototype. Last time > I laid up a board I used a drafting table and mylar. I may need a bit > of handholding as I go along.
Where are you based? US / Europe / UK? I make the Europe / UK distinction partly to wind up main-land Europeans ;), and partly because I'm far more likely to be able to suggest a fab-house in the UK than (say) Germany. (And yes, UK residents typically use terms like "I just came back from Europe", and neglect to remember we're all part of the same union). -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) Tel: +44 (0)1223 748328 - (Shared lab phone, ask for me) _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user