Please take a look here: http://geda.seul.org/wiki/geda:csygas
I had trouble in the past with gEDA <-> SPICE because of the rule: Note that if the file holds a .MODEL, the refdes should start with U; if the file holds a .SUBCKT, the refdes should start with X. If the refdes starts with D SPICE will assume the internal model. This is what I remember, hope it helps. Regards, Robert. On Wed, 2010-05-26 at 13:34 +0530, hari venkatesh wrote: > I am new user of gEDA i have seen the ngspice manual and implemented > the rc circuit given in the ngspice manual. But when i tried to > implement Fullwave Rectifier cicuit given in the manual, i was not > getting the transient response properly. > > After entering $ ngspice [1]fulladder.net > > > > It is giving error "unable to find defination of the model 1n4148 > default assumed" > > > > i have tried to give model in single line specification by selecting > attribute model IS=1pA RS=10 BV=100, but still same error was comming > > > > even tried to assign model file but still same error was comming.... > > > > help meeeeee > > References > > 1. http://fulladder.net/ > > _______________________________________________ > geda-user mailing list > geda-user@moria.seul.org > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user