I'm not sure I understand the problem with #1. Can't you take the
mostly routed design and back annotate the jumpers so that they are
parts in the original schematic? Then you get what you are looking
for in #3 which you think is the best approach.
Rick
At 12:17 PM 10/16/2010, you wrote:
Hello,
I am trying to design a single-sided board with SMD components only
(no drilling). The toporouter (which is absolutely awesome, btw.)
routes almost all rat lines with only several left unresolved. But,
what now? I can do several things:
1) Make the PCB and connect suitable places with wire.
disadvantage: The PCB cannot be published without further
explanation. And, it is not beautiful.
2) Insert dummy components like zero-ohm resistors or jumper wire in
schematics with the hope, that some traces can be routed below the components.
disadvantage: The schematics looks crazy. Moreover, surprisingly,
it does not help. The autorouter "sees" different circuit and
magically designs different traces. Often, number of unresolved rat
lines increases. And, it is totally unpredictable where exactly to
insert the "dummy" components and how many of them.
3) Make "double sided" PCB and the other side realize with wire bridges only.
Disadvantage: This is a bad idea as number of vias is much higher
that number of unresolved rat lines.
4) Use #1 but do some manual post-processing.
disadvantage: At any change in the schematics the manual work
must be done again.
The best solution (for me) would be #3 if:
- the number of vias would be as small as possible
- vias should be in pairs so that the wire connects exactly two.
Or this:
- if some rat lines cannot be solved, make a pair of pads (or pins) for them.
Does anyone have an idea?
Thank you very much,
Jan Martinek
_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user