Can you still get single sided FR2?



On May 31, 2011, at 2:26 PM, Thomas Oldbury <toldb...@gmail.com> wrote:

>   Double sided boards are great, but not so great when the product is
>   supposed to cost only $3/each, after an MSP430, mains power supply,
>   heatsink, triac etc.
> 
>   On 31 May 2011 22:09, Levente Kovacs <[1]leventel...@gmail.com> wrote:
> 
>   On Tue, 31 May 2011 21:59:04 +0100
>   Thomas Oldbury <[2]toldb...@gmail.com> wrote:
>> Oh. Thanks anyway. Any hack-ish way to add this in? (Because I'd like
>> each jumper to have a refdes and BOM entry if possible.)
> 
>     What I'd do is define a copper layer. Draw your jumpers on the that
>     layer.
>     Don't send the layer data to the fab house. Make sure you have mask
>     openings
>     on vias. Solder jumpers in the vias.
>     I recommend using double sided boards.
>     Levente
>     --
>     Levente Kovacs
>     [3]http://levente.logonex.eu
> 
>   _______________________________________________
>   geda-user mailing list
>   [4]geda-user@moria.seul.org
>   [5]http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
> 
> References
> 
>   1. mailto:leventel...@gmail.com
>   2. mailto:toldb...@gmail.com
>   3. http://levente.logonex.eu/
>   4. mailto:geda-user@moria.seul.org
>   5. http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
> 
> 
> _______________________________________________
> geda-user mailing list
> geda-user@moria.seul.org
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user


_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

Reply via email to