On Thu, Jun 02, 2011 at 11:45:01PM +0200, Kai-Martin Knaak wrote: > Hi. > > A fresh clone from git of PCB just failed on me with memory error. While > I did some manual routing of a fairly large layout (~1700 components) the > application died after several minutes. There was an error message on the > command line: > > ***MEMORY-ERROR***: pcb-head[21193]: GSlice: failed to allocate 248 bytes > (alignment: 256): > Cannot allocate memory > > Anything I can do to help diagnose the problem, if this happens again? >
Use gdb to get a backtrace (gdb ./pcb, then r to run, bt to backtrace). -- Andrew Poelstra Email: asp11 at sfu.ca OR apoelstra at wpsoftware.net Web: http://www.wpsoftware.net/andrew/ _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user