Em Qui 06 Jan 2005 09:26, Karel Kulhavy escreveu: > Hello > > I have a big rectangle in solder layer. A via is through it. A smaller > rectangle is over the via that is threated using 's' to make it connect > to the via. The smaller rectangle is blue (GND-sldr). > > I want to move the small rectangle into solder layer. I tried from both > sides of the board using 'm' key while my current layer was solder > and didn't succeed. > > Is there any other method how to move the rectangle? > > Cl<
Well, I think your problem is to connect a via to a rectangle, am I right? I do it in another way (I dont knew about using s can connect a via to a rectangle, lifing and learning :D ): I draw the rectangle, put the via over it, draw a little line, increase it size with s until it gets bigger that the via, place over it and press j over the line. So you dont need to move nothing from one layer to another. But, if you draw a rectangle in the solder layer, place a via, draw another rectangle (smaller) over the via (it will become invisible, off course) and press s over the area of the smaller rectangle, you will connect the via too.
