El lun, 06-03-2006 a las 16:29 +0100, Wojciech Kazubski escribió: > > > Is it possible to get warning or error when I have two resistors named > > > R1 in my schematic? I always don't notice this and then get bullshit > > > simulation. > > > > Doesn't DRC2 check for this? > > > Many DRCs does not detect this if both component have the same value. Old > Orcad was giving the warning that a component has two values. If they were > equal the program treated them as one component connected to both places. > This is done to allow sloting (several components with the same refdes) > Mayby it is possible to test if certain pin is used twice?
Check the drc2 backend. If you find a not included (and feasible) test that can be done, I will happily try to add it. Regards, Carlos
