Hi Yasir, I just wanted to say that se.py works without problems in the cxx config. And I confirmed that there is an issue with the TLM setup and se.py.
Regards Matthias > Am 08.06.2017 um 14:43 schrieb Qureshi Yasir Mahmood <[email protected]>: > > Hi Matthias, > > Thank you for the reply. When you say " Using util/cxx_config with se.py or > fs.py with util/tlm works fine", do you mean I should compile the > build/examples/slave_port/gem5.sc using cxx_config ? > > Regards > Yasir > > > -----Original Message----- > From: gem5-users [mailto:[email protected]] On Behalf Of Matthias > Jung > Sent: 07 June 2017 23:50 > To: gem5 users mailing list <[email protected]> > Subject: Re: [gem5-users] SystemC and GEM5 SE Mode > > Hi Yasir, > > I just had a short look, indeed there is an issue. > Using util/cxx_config with se.py or fs.py with util/tlm works fine. > We will have a deeper look into it. > > Regards > Matthias > > >> Am 07.06.2017 um 18:22 schrieb Qureshi Yasir Mahmood <[email protected]>: >> >> Hello All, >> >> I am trying to setup a GEM5-SystemC co-simulation with gem5 running in SE >> mode. I have followed the tutorial in /util/tlm/README file and I can run >> the example provided. But when I try to run GEM5 in SE with TLM enabled, I >> get the following error, >> >> First to build the config file, I run >> >> ../../build/ARM/gem5.opt ../../configs/example/se.py >> --tlm-memory=transactor --mem-type=SimpleMemory --mem-size=512MB >> --mem-channels=1 -c ../../../helloworld/hevc >> >> And then to run >> >> bash-4.2$ build/examples/slave_port/gem5.sc m5out/config.ini >> >> SystemC 2.3.1-Accellera --- May 31 2017 13:14:37 >> Copyright (c) 1996-2014 by all Contributors, >> ALL RIGHTS RESERVED >> ============================================================ >> EventQueue Dump (cycle 0) >> ------------------------------------------------------------ >> <No Events> >> ============================================================ >> 0: system.remote_gdb.listener: listening for remote gdb #0 on port 7000 >> 0 s (=) : sc_main Start of Simulation >> warn: ClockedObject: More than one power state change request encountered >> within the same simulation tick >> fatal: Out of memory, please increase size of physical memory. >> Memory Usage: 597116 Kbytes >> >> >> Can anyone please let me know, if I need to have a separate physical memory >> for this and hence modify the se.py file or just control it through the >> configuration options ? >> >> Regards >> Yasir >> _______________________________________________ >> gem5-users mailing list >> [email protected] >> http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users > _______________________________________________ > gem5-users mailing list > [email protected] > http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users > _______________________________________________ > gem5-users mailing list > [email protected] > http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users _______________________________________________ gem5-users mailing list [email protected] http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users
