I see. I'm not sure about that but you could read the technical report @
http://www.hpl.hp.com/research/mcpat/ .
Max
On 06/08/2010 04:33 PM, Weixun Wang wrote:
That is OK for off-line calculation based on simulation statistics. Is
it possible to make it online like what Wattch does?
-Weixun
On 6/8/2010 10:28 AM, Maximilien Breughe wrote:
Hi,
You could use McPAT for this and use the M5 statistics as input.
The catch is that you'll have to write a parser to parse the m5
statistics and configuration file.
The parser should then write the input for mcpat in the proper XML
format.
Good luck!
Max
PS: I wrote such a parser, tailored for a simple in order core. It's
not general at all, but it could inspire you a bit.
On 06/08/2010 04:23 PM, Syed Shazli wrote:
Hi,
I was wondering if it was possible to do any power estimation in M5.
Something similar to the way it is done in simplescalar?
Best,
Syed
_______________________________________________
m5-users mailing list
[email protected]
http://m5sim.org/cgi-bin/mailman/listinfo/m5-users
_______________________________________________
m5-users mailing list
[email protected]
http://m5sim.org/cgi-bin/mailman/listinfo/m5-users
--
Best Regards,
Wang, Weixun
Department of Computer& Information Science& Engineering
Gator College of Engineering
University of Florida
Gainesville, FL 32611
http://www.cise.ufl.edu/~wewang
_______________________________________________
m5-users mailing list
[email protected]
http://m5sim.org/cgi-bin/mailman/listinfo/m5-users
_______________________________________________
m5-users mailing list
[email protected]
http://m5sim.org/cgi-bin/mailman/listinfo/m5-users
