Thanks Bill,
For both of bin/jconsole and bin/libj.so I get the following response from
ldd:
not a dynamic executable
I'm going to try some of the other J versions and also try to recreate my
previous setup (where J805 was working). If all that fails I'll try
building J from source.
On Tue, Aug 1, 2017 at 11:56 AM, bill lam <[email protected]> wrote:
> raspberry j binaries were built for raspbian which is
> 32-bit, hard float abi targeted for armv6. I have no
> experience with ubuntu on raspberry, but you may try
> ldd on jconsole and libj.so to see if all dependencies
> are satisfied.
>
> Вт, 01 авг 2017, Alex Shroyer написал(а):
> > Recently I attempted to install j805 (raspberry) on a fresh Ubuntu 16.04
> > installation and ran into errors.
> >
> > Specifically, when I tried to run the jconsole executable, I got a "file
> > not found" which I tracked down to mean "wrong architecture".
> >
> > The computer I'm using is an arm64 architecture, but in the past I have
> > been able to run the unmodified j805/raspberry release.
> >
> >
> > My strong hunch is that this fresh Ubuntu install doesn't have some sort
> of
> > compatibility-providing package which I had previously installed, and the
> > problem is I don't know what package that is.
> >
> >
> > Any help would be appreciated!
> > Thanks,
> > Alex
> > ----------------------------------------------------------------------
> > For information about J forums see http://www.jsoftware.com/forums.htm
>
> --
> regards,
> ====================================================
> GPG key 1024D/4434BAB3 2008-08-24
> gpg --keyserver subkeys.pgp.net --recv-keys 4434BAB3
> gpg --keyserver subkeys.pgp.net --armor --export 4434BAB3
> ----------------------------------------------------------------------
> For information about J forums see http://www.jsoftware.com/forums.htm
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
