Duncan wrote:
Pause every few seconds. I've seen two commonly reported solutions to
this -- two different problems resulting in the same symtoms -- and
another one less common in general but likely equally common on amd64.
1) DMA, or rather, the lack thereof, or interrupt sharing. Ensure that
you have the correct chipset drivers installed, both for whatever bus the
NIC is on, and for your hard drive interface (the PATA/SATA/SCSI chipset).
Often, generic or the wrong drivers will work in degraded mode, but DMA
won't be turned on, and performance will suffer. For your hard drives
(yes, wrong drivers there /can/ cause bottlenecks up the chain, including
onto the same bus as the NIC), use hdparm (or sdparm) to verify that both
the drive and the chipset agree that DMA is on.
I am using the Promise EX8350 raid card and using there driver.
Also check interrupt distribution and sharing. You may be able to change
these settings in the BIOS, or try switching some cards around
(particularly your NIC if it's not on-board built-in).
This one I was thinking of trying the last. (Read below)
2) Do you have an "extra" network interface? I've seen this one on
MSWormOS and am unsure how Linux would even have the problem, unless you
have a spare interface (say a wireless card) that's running but not
connected. Anyway, the problem here is an interface set to DHCP mode that
can't get an IP because it's not connected, so of course can't see a
server. The system would pause every few minutes (every few seconds seems
a bit much, but...) and try to obtain an IP, stalling all I/O in the
process. (Again, the reason it's stalling all I/O is likely rooted in
misconfigured DMA or IRQs, but anyway...)
All the network cards are set to static address.
3) Seen frequently on this list as a problem resulting in one or more of
a number of symtoms, including this one: APIC or ACPI problems. Take a
look at the kernel documentation under $kerneldir/Documentation/x86_64,
the apic and acpi boot options, and idle=poll as well. Note that those
needing these often find they don't after a mature BIOS is available and
flashed. idle=poll is particularly nasty, as it will cause your CPU to
work far harder and run far hotter than it ordinarily would, but some
early amd64 boards required it until an updated BIOS fixed the issue. I'm
not sure if that's still a problem with the newer boards or not.
I am using the latest bios. So far I am not using any apic boot options. Will
read up.
Also note that for specific net chip, various configuration options may be
available. In particular, there's the Broadcom tigon3/tg3 kernel driver,
and then another (I forget what it's called) for the same net chip. Often
one will work well, the other won't work or will have issues. If that's
your chip, look it up and consider trying the other driver.
Will check this.
Thank you very much for replying and helping. Please read my observations below
and if you have time please advice. Let me know if I still have to do the checks
as mention above.
Here are some specs and observations.
Specs.
cpu: AMD 64 3000+
drives: Sata drives
mobo: MSI Neo 4 Platinum
Ram: 2GB
Raid: Promise EX8350
OS: Gentoo
Kernel: 2.6.13 r3
Filesystem: XFS
Observations.
When I was using the xfs I had the problem of the pauses in the tcp transfers.
These pauses, I am guessing is because of the pdflush that occurs around every
20 seconds. There is only one pdflush every 20 seconds. This caused lose of
video frames when we did the video recording. The video would have a jerk or
jump when played back.
I changed the dirty_ratio from the default of 40 to 5. This solved the problem.
During the recording preview there seems to be some jerks but during the
playback it seems to be ok. The pdflush happens more often and there is still
one pdflush. I think the jerk that I see in the record preview coincides with
the pdflush. More jerks in record preview but ok during playback.
Next I formatted the drives to the ext3 filesystem. The dirty_ratio was set back
to the default value of 40. When the video started to record there is no loss of
frames and no jerks in the preview window. During the playback there is no loss.
Everything is good. Check the top for pdflush and noticed that the there is two
pdflush. The pdflushs is happening at every 5 seconds or so. Very fast compared
to when I was using xfs.
So the problem must be my xfs setting. For xfs I have only used the default
setting. Or could there be a problem with xfs and AMD64 kernel?
What must I do to get xfs to work? Or what am I doing wrong?
Please comment and advise.
Once again thank you very much for the advice.
P.V.Anthony
--
[email protected] mailing list
