I was having this hangup problem. I took the "userpriv" and "usersandbox" settings out of /etc/make.conf and the problem went away.
Chris -----Original Message----- From: Mark Saunders [mailto:[EMAIL PROTECTED] Sent: Thursday, March 20, 2003 3:11 PM To: [EMAIL PROTECTED] Subject: Re: [gentoo-user] emerge/distcc problems i can't even emerge portage... bash-2.05b# emerge portage Calculating dependencies ...done! >>> emerge (1 of 1) sys-apps/portage-2.0.47-r10 to / >>> md5 ;-) portage-2.0.47-r10.tar.bz2 >>> Unpacking source... tar xjf /usr/portage/distfiles/portage-2.0.47-r10.tar.bz2 >>> Source unpacked. anyone have any idea what is going on? On Fri, 2003-03-21 at 09:41, Mark Saunders wrote: > while it is hanging, gcc is sapping 95% of cpu time.. > > On Fri, 2003-03-21 at 09:36, Mark Saunders wrote: > > Yesterday i emerged distcc and had a play with it. > > Seemed to work fine. > > > > Today i wanted to emerge some stuff without distcc > > because i wanted athlon optimization. > > > > But now all emerge hang during configure like this... > > > > i've commented out the "FEATURES", "MAKEOPTS" and "DISTCC_HOSTS" lines > > in > > make.conf. > > > > >>> Source unpacked. > > configure: WARNING: If you wanted to set the --build type, don't use > > --host. > > If a cross compiler is detected then cross compile mode will be > > used. > > checking build system type... -- Mark Saunders <[EMAIL PROTECTED]> Cytek Pty Ltd -- [EMAIL PROTECTED] mailing list