I had the same problem with gentoo-sources. Went back to generic sources. On Tue, 2003-10-28 at 20:35, Stewart C. Russell wrote: > Are there any known problems with Athlon XP kernels and a plain old > Adaptec 2940? I have one driving a slide scanner and a CD-ROM, and it > fails to initialise. > > After successful POST, and the Adaptec screen identifies the devices > hanging off the chain, the init procedure gets knocked for a loop. It > gets stuck producing messages like: > > host 1 abort timed out - bus is being reset > (scsi:0:-1:-1) Disconnected list inconsistency ... > Yikes! There is a loop in the free list ... > > and this goes on and on, bumping the pid up by one as it goes. > > It worked fine under Redhat 7.3 (kernel 2.4.20-20.7). I'm a little > suspicious that the card might be borked, as Knoppix 3.2 didn't pick up > any devices on the chain. > > I tried setting "acpi=no" in the kernel parms, but that didn't help. I > haven't yet tried to restart under RH7.3; that would involve a bit of > hard-drive shuffling. > > Ideas, suggestions, replacement cards welcomed. > > thanks, > Stewart -- Lincoln A. Baxter <[EMAIL PROTECTED]>
-- [EMAIL PROTECTED] mailing list