http://dev.gentoo.org/~spider/gentoo.dell.blade.txt
Fabien
[EMAIL PROTECTED] wrote:
Hi there,
I'm trying to install Gentoo on a HP xw8000 computer (2 Xenon 3.0 GHz processors) but have some SCSI problems. The computer has been setup with only a SCSI and no IDE harddrive. The IDE CDROM works OK. The SCSI controller is a dual channel Ultra 320SCSI. At boot I use
# gentoo doscsi
(I've tried "smp doscsi" but my screen goes black , even if I add the "nofb" and/or "agpgart" option)
There is only an empty /dev/scsi directory and no sdXX entries in /dev after boot.
The gentoo hardware detection procedure finds only one processor (of course, standard gentoo kernel), the mouse at /dev/psaux, the netowrk device at eth0 and the sound and videocard. All that stuff seems OK. But no SCSI controllers or devices.
The dmesg output says: SCSI subsystem driver Revision: 1.00 kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 <repeat two more times>
# cat /proc/scsi/scsi Attached devices: none
# cat /proc/pci/pci <...> Bus 3, device 5, function 0: SCSI storage controller: LSI Logic <....> 53c1030 (rev 7) IRQ 3. Master capable <...> I/O at 0x2000 [0x20ff] Non-prefetchable 64 bit memory at 0xda110000 [0xda11ffff] Non-prefetchable 64 bit memory at 0xda110000 [0xda10ffff] Bus 3, device 5, function 1: SCSI storage controller: LSI Logic <....> 53c1030 (#2) (rev 7) IRQ 3. Master capable <...> I/O at 0x2400 [0x24ff] Non-prefetchable 64 bit memory at 0xda130000 [0xda13ffff] Non-prefetchable 64 bit memory at 0xda120000 [0xda12ffff]
Not much experice with SCSI. Can anyone immediately see the problem ?
-- Harald Iwe
-- [EMAIL PROTECTED] mailing list
-- [EMAIL PROTECTED] mailing list