Once again, thank you all for your tips. this card was using the msp3400 module. But it couldn't be loaded because i had to add a firmware for Hotplug to load it.
now the dmesg shows : bttv: driver version 0.9.15 loaded bttv: using 8 buffers with 2080k (520 pages) each for capture bttv: Bt8xx card found (0). ACPI: PCI interrupt 0000:00:09.0[A] -> GSI 17 (level, low) -> IRQ 17 bttv0: Bt878 (rev 17) at 0000:00:09.0, irq: 17, latency: 32, mmio: 0xe3002000 bttv0: detected: Hauppauge WinTV/PVR [card=80], PCI subsystem ID is 0070:4500 bttv0: using: Hauppauge WinTV PVR [card=80,autodetected] bttv0: gpio: en=00000000, out=00000000 in=00ffffff [init] bttv0: altera firmware upload ok bttv0: Hauppauge eeprom: model=45226, tuner=Philips FI1216MF MK2 (3), radio=no bttv0: using tuner=3 bttv0: i2c: checking for MSP34xx @ 0x80... found msp34xx: ivtv version msp34xx: init: chip=MSP3415D-B3, has NICAM support, simple (D) mode msp34xx: $Id$ compiled on: Feb 6 2005 01:17:04 msp3410: daemon started bttv0: i2c: checking for TDA9875 @ 0xb0... not found bttv0: i2c: checking for TDA7432 @ 0x8a... not found tvaudio: TV audio decoder + audio/video mux driver tvaudio: known chips: tda9840,tda9873h,tda9874h/a,tda9850,tda9855,tea6300,tea6420,tda8425,pic16c54 (PV951),ta8874z bttv0: i2c: checking for TDA9887 @ 0x86... not found tuner: chip found at addr 0xc2 i2c-bus bt878 #0 [sw] tuner: type set to 3 (Philips (SECAM+PAL_BG) (FI1216MF, FM1216MF, FR1216MF)) by bt878 #0 [sw] bttv0: registered device video1 bttv0: registered device vbi0 bttv0: PLL: 28636363 => 35468950 .. ok once the altera formware was uploaded, all went ok. I hope that can help. JiPé -- gentoo-user@gentoo.org mailing list
