I've tried everything I can find by googling. Tried the forums. Can't
find anything that solves the issue. I have noapic as a kernel parameter
in grub. I still get this error in dmesg:
tulip0: MII transceiver #1 config 1000 status 786d advertising 01e1.
eth0: ADMtek Comet rev 17 at d12c8000, 00:03:6D:1D:89:41, IRQ 9.
ohci_hcd: 2004 Nov 08 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
0000:02:0d.0: tulip_stop_rxtx() failed
eth0: Setting half-duplex based on MII#1 link partner capability of 0021.
Here is the relevant result of lspci-vv:
0000:02:0d.0 Ethernet controller: Linksys NC100 Network Everywhere Fast
Ethernet 10/100 (rev 11)
Subsystem: Linksys: Unknown device 0570
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (63750ns min, 63750ns max), cache line size 08
Interrupt: pin A routed to IRQ 9
Region 0: I/O ports at d000
Region 1: Memory at ed800000 (32-bit, non-prefetchable) [size=1K]
Capabilities: [c0] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Here is the result of mii-diag:
Using the default interface 'eth0'.
Basic registers of MII PHY #1: 1000 786d 0022 5410 01e1 0021 0004 2001.
Basic mode control register 0x1000: Auto-negotiation enabled.
You have link beat, and everything is working OK.
Your link partner is generating 10baseT link beat (no autonegotiation).
End of basic transceiver information.
Does anyone have anymore ideas on what to try to get rid of the
tulip_stop_rxtx() failed problem? The patches I found by googling this
error didn't work.
--
Kathy Wills
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+ Genealogy Web Site: http://www.brannanorwills.com +
+ +
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
--
gentoo-user@gentoo.org mailing list
