-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 On 08.10.2012 14:52, James wrote: > Hinnerk van Bruinehsen <h.v.bruinehsen <at> fu-berlin.de> writes: > > >> Ok - you're trying two different approaches at the same time. >> I'd recommend you to just use the printer-drivers overlay. > > Yep know doubts, I looked at too many different wiki and other > googled resources. I could not find a simple here are the steps to > installing "printer" overlays, compiling them, making the config > changes and then testing via CUPS. > > OK, I'll the print drivers first. > >> Normally layman should take care of the contents of >> /var/lib/layman/make.conf. Maybe it doesn#t work because you >> created an empty one. You could try to simply delete it and >> afterwards rerun layman -a printer-drivers. If that doesn't solve >> your problem, recreate the file with the following content: > >> PORTDIR_OVERLAY=" $PORTDIR_OVERLAY" > >> Afterwards try layman -a printer-drivers again. > > #layman -l * printer-drivers [Git ] > (git://git.o.g.o/proj/printer-drivers.git ) * zugaina > [Rsync ] (rsync://gentoo.zugaina.org/zugaina-portage ) > > OK it's installed. I would think emerging it is next? But that does > not seem to work with emerge?
Sounds fine up to here. Make sure you have a line "source /var/lib/layman/make.conf" inside your make.conf and try to emerge the driver. It should work then. -----BEGIN PGP SIGNATURE----- Version: GnuPG v2.0.19 (GNU/Linux) Comment: Using GnuPG with Mozilla - http://www.enigmail.net/ iQEcBAEBAgAGBQJQc/elAAoJEJwwOFaNFkYccQgH/j5PPQOOLoz04NmohiiqpSCQ 6xZ6X3qq1KgzUlJOXnQ2YnQpbaVGB1vTGddXCxytPfqSucCVFWCZkP/HsqrShWss f7u2SaXmTP4TDoqx0tFpyReRhhv7hZATcGH9PpWVc+G8iSnyB5HJZOVzWFhPow/9 xXE3YxdKvEYPnru+LwjOBBVQJ1ktRsHbi2j6nQm5LTcZtSOrUq+OeEpRru5uswv5 ALruHbz8o90DeQycMyjXaDnwMcQ2o9IIdarVWSTaaxhCONB4OXC4XJ7egOJdC+Qa DUB0myfNwKInn7hoqVV2cZys4tOIJ/+imiz0BYEKJR72roKm7B/chKFunWlooSE= =e0Eu -----END PGP SIGNATURE-----
