On Sunday 12 Feb 2017 01:07:09 the...@sys-concept.com wrote: > On 02/12/2017 01:01 AM, the...@sys-concept.com wrote: > > My local network is 10.0.0.1 - > > > > I have an external device that is pre-set from factory to 192.168.1.100 > > and I need to access to it via browser to change its network setting. So > > I do: > > ifconfig net0:1 192.168.1.1 up > > > > nmap -sn 192.168.1.1/24 > > > > Starting Nmap 6.47 ( http://nmap.org ) at 2017-02-12 00:54 MST > > Nmap scan report for 192.168.1.100 > > Host is up (0.00015s latency). > > MAC Address: 00:09:45:41:73:D1 (Palmmicro Communications) > > Nmap scan report for 192.168.1.1 > > Host is up. > > Nmap done: 256 IP addresses (2 hosts up) scanned in 3.78 seconds > > > > The device is showing up but I can not ping it, 100% packet loss. > > ifconfig is showing: > > net0:1: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 > inet 192.168.1.1 netmask 255.255.255.0 broadcast 192.168.1.255 > ether 00:1b:21:b8:27:b6 txqueuelen 1000 (Ethernet) > device interrupt 16 memory 0xfddc0000-fdde0000 > > -- > Thelma
Are you sure the device is configured to respond to pings? Are your routes on the PC configured correctly, if you are using a secondary interface on the same NIC? Does nmap -A -T4 -Pn -vvv 192.168.1.100 show any services running to which you can connect? -- Regards, Mick
signature.asc
Description: This is a digitally signed message part.
