I did plug the device IN and it was recognized.
Well, in my case "/dev/ttyUSB*" does not appear at all.
There are 325 "tty*" devices but non of them that starts as: ttyUSB
here is dmesg:
USB Mass Storage support registered.
usbcore: registered new interface driver usbserial
drivers/usb/serial/usb-serial.c: USB Serial Driver core
drivers/usb/serial/usb-serial.c: USB Serial support registered for Garmin GPS
usb/tty
usbcore: registered new interface driver garmin_gps
drivers/usb/serial/garmin_gps.c: garmin gps driver v0.31
...
dmesg when I plug it to USB port.
scsi 0:0:0:0: Direct-Access Garmin nuvi Flash 1.00 PQ: 0 ANSI: 5
sd 0:0:0:0: [sda] 2946989 512-byte hardware sectors (1509 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 23 00 00 00
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] 2946989 512-byte hardware sectors (1509 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 23 00 00 00
sd 0:0:0:0: [sda] Assuming drive cache: write through
sda:
sd 0:0:0:0: [sda] Attached SCSI removable disk
sd 0:0:0:0: Attached scsi generic sg0 type 0
scsi 0:0:0:1: Direct-Access Garmin nuvi SD Card 1.00 PQ: 0 ANSI: 5
sd 0:0:0:1: [sdb] Attached SCSI removable disk
sd 0:0:0:1: Attached scsi generic sg1 type 0
usb-storage: device scan complete
So, someting is not working with this Garmin USB kernel driver :-/
--
#Joseph
GPG KeyID: ED0E1FB7
On 05/20/08 13:52, W.Kenworthy wrote:
If its like the palm syncing over usb - they only appear when the device
is plugged in/active. Yes its a pain ...
BillK
On Mon, 2008-05-19 at 23:49 -0600, Joseph wrote:
I've compiled Garmin USB support into kernel but after rebooting it did not create pseudo-serial port called
"/dev/ttyUSB0"
How to troubleshoot it?
--
gentoo-user@lists.gentoo.org mailing list
