I would suggest that an important limitation of this and similar studies
for application in planning small-scale field experiments of injecting
aerosols into the stratosphere is that the results do not consider the
gravitational, density driven spreading that was evident when a mass of
well-mixed, polluted air was introduced into the inversion above Los
Angeles and formed a thin, polluted layer across the whole basin. The
particular situation of the initially mysterious layers was explained by
UCLA meteorologist and professor James Edinger. His explanation was that
afternoon sunlight striking the west and southwest facing hillsides
surrounding the LA basin heated a thin layer of polluted air below the
inversion enough to allow it to rise along the hillside surface without
cooling by expansion until the air reached the tops of the hills (up to
a few thousand meters high). Once there and not further heated, the
polluted air could not rise further and so spread out at that altitude,
not by advective flow or mixing by the type of turbulence being measured
by fixed volume balloons that don't allow spreading. The spreading was
because the air was of the same density as the air at just that level.
The spreading flow led to thin polluted layers in the inversion covering
much of the basin dependent on the particular heights of each of the hills.
Cal Tech did lab tank experiments verifying that this phenomenon
could/would occur. The expert on all of this is atmospheric chemistry
professor John Seinfeld of Cal Tech. As far as I know this phenomenon
has not been considered in the planning of the injection experiments and
I'd suggest it would make keeping track and measuring the injected
material much more difficult (e.g., by a maneuvered balloon) and the
concentrations considerably lower than has been planned for.
I think the rapid dispersal of contrails created by aircraft in
relatively dry air is also an example of the spreading phenomenon. In
relatively saturated air, such as where cirrus are already present,
contrails tend to persist, but in dry air the contrails disappear
rapidly (seconds to tens of seconds). In the proposed experiments, the
air would be relatively clean and so spreading would quite likely
quickly dilute the injected pollutants, reducing the likelihood (so
rate) of the chemical reactions planned to be determined. Attempting the
measurements in a volcanic plume might be possible, but then one does
not have controlled conditions.
My personal view is that small-scale experiments are unlikely to provide
useful results, and that the approach needed is going to be to start
with small, initial deployment scale injections based on estimated rates
of reactions from volcanic injections and to observe, adjust, and learn
as SAI is slowly strengthened to exert a cooling influence.
Mike MacCracken
On 4/11/26 9:30 AM, Geoengineering News wrote:
https://arxiv.org/abs/2604.04040
*Authors: *Han-Chang Ko, Hongwei Sun
*05 April 2026*
*Abstract*
Stratospheric turbulence is difficult to observe, yet it strongly
affects how momentum, trace gases, and aerosols spread through the
atmosphere. Here, we use global high-resolution radiosonde
observations from 370 stations during October 2014-December 2025 to
estimate stratospheric turbulent diffusivity with a
Richardson-number-based method. We find that turbulent diffusivity
spans a broad range and is dominated by turbulence occurring in
statically stable but strongly sheared conditions. Enhanced values
appear over Turkey, India, Malaysia, Japan, and major mountainous
regions, with evidence that mountain waves and convective activity
both contribute. We also identify a local maximum just above the
tropical tropopause, between the Equator and 15 N at 17 km altitude,
which may indicate an injection region conducive to the rapid aerosol
dispersion for stratospheric aerosol injection (SAI). Stratospheric
turbulent diffusivity also shows
a significant increase (3.5 x10^-3m^2s^-1/yr. Finally, these results
may help constrain and predict the dispersion of stratospheric plumes
from rockets, aircraft, and potential SAI.
*Source: ArXiv *
--
You received this message because you are subscribed to the Google
Groups "geoengineering" group.
To unsubscribe from this group and stop receiving emails from it, send
an email to [email protected].
To view this discussion visit
https://groups.google.com/d/msgid/geoengineering/CAHJsh99WfRgxjOFx060PBpaqbzUuBhUVTEPB8fSxMc6zkkA10A%40mail.gmail.com
<https://groups.google.com/d/msgid/geoengineering/CAHJsh99WfRgxjOFx060PBpaqbzUuBhUVTEPB8fSxMc6zkkA10A%40mail.gmail.com?utm_medium=email&utm_source=footer>.
--
You received this message because you are subscribed to the Google Groups
"geoengineering" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion visit
https://groups.google.com/d/msgid/geoengineering/c0121b85-0036-43fa-b510-559d23773c15%40comcast.net.