Did you enable the auto IP/MAC generation? You can do this by going to the "config" menu option and selecting the
"Toggle IP/MAC Auto-gen" option. After doing this, save the topology and recompile the error should go away. From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of kelvin poon Sent: September-24-08 10:20 AM To: gini@cs.mcgill.ca Subject: [gini] Configuring the mask of an interface Hi, I keep getting the follow error when i try to compile my topology see attached The mask of interface 1of UML_1is not valid may i know how can I configure the mask of an interface? Kelvin Poon
_______________________________________________ gini mailing list gini@cs.mcgill.ca http://mailman.cs.mcgill.ca/mailman/listinfo/gini