A work around could be using a transfinite mesh. Try adding the
following lines to your file:
Transfinite Line{r1,r2} = 2/c ;
Transfinite Line{r3,r4} = 5/c ;
Transfinite Surface(s);
Regards,
Ruth
On 15/09/10 14:25, Regis Duvigneau wrote:
Hi,
When a ruled surface is generated with a BSpline as boundary,
some triangles at other boundaries are strongly stretched,
whatever the algorithm used, yielding a computational grid of
very poor quality. (see attached geo file and figure).
Does anyone has a solution to correct this ?
Thanks in advance.
Régis Duvigneau
-----------------------------------------------------------------
Regis Duvigneau
Permanent Research Associate
INRIA Sophia Antipolis - OPALE
Project-Team
-----------------------------------------------------------------
2004 route des lucioles, 06902
Sophia-Antipolis
tel: (33)4 92 38 71 77
fax:(33)4 92 38 79 80
-----------------------------------------------------------------
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
--
Dr. Ir. Ruth V. Sabariego
University of Liege, Dept. of Electrical Engineering & Computer Science,
Applied & Computational Electromagnetics (ACE),
phone: +32-4-3663737 - fax: +32-4-3662910 - http://ace.montefiore.ulg.ac.be/
|
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
