On Thursday 25 September 2014 06:34:05 [email protected] wrote:
> I have the same problem.
> Does anyone found a better solution than the one Omid suggested ?
It works if you have Points (geometric entities) at the location of the
intersection of the embedded lines with the surface contour. See the attached
file.
In an ideal world gmsh would discover that these points need to be inserted
into the line loop of the surface, before starting the meshing process.
Probably a point for a todo list...
Regards
ZP
lc = 0.05;
Point(1) = {4, 1.7, 0, lc};
Point(2) = {4.5, 1.7, 0, lc};
Point(3) = {4.5, 1.4, 0, lc};
Point(4) = {4, 1.4, 0, lc};
Point(5) = {4.1, 1.7, 0, lc};
Point(6) = {4.1, 1.6, 0, lc};
Line(1) = {4, 3};
Line(2) = {3, 2};
Line(3) = {2, 5};
Line(4) = {5, 1};
Line(5) = {1, 4};
Line(6) = {5, 6};
Line Loop(7) = {5, 1, 2, 3, 4};
Plane Surface(8) = {7};
Line{6} In Surface{8};
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
