Dr. Sabariego, I'm writing as I found an old message from you regarding duplicate nodes in GMSH on a discussion forum. I'm new to using GMSH and I was hoping that you could offer some advice on how to avoid this issue (after meshing, the duplicate nodes cause my FEA analysis to fall to pieces). My methodology so far has been to create shapes in Solidworks via extrusion, then to import the .IGS file into GMSH and to mesh. I've attached my .IGS file and my .MSH file in case you have time to look at them. Thanks in advance for any counsel you can offer.
Aaron J. Kiefer MSME, PE Accident Research Specialists, PLLC 1631 NW Maynard Road, Suite 101 Cary, NC 27513 Phone: (919) 467-8134 Fax: (919) 678-1261 Cell: (919) 810-8429 Email: [email protected]<mailto:[email protected]> Web: www.accident-research.com<http://www.accident-research.com/> Email Confidentiality Notice: The information contained in this transmission is confidential, proprietary, and/or privileged. The message is intended for the sole use of the individual or entity to whom it is addressed. If you are not the intended recipient, please be advised that any use, distribution, or copying of the message is strictly prohibited and may be subject to penalties, If you received this transmission in error, please contact the sender immediately and delete this material from any computer.
Guard3D.msh
Description: Guard3D.msh
SemiTrailerGuard3.IGS
Description: SemiTrailerGuard3.IGS
_______________________________________________ gmsh mailing list [email protected] http://www.geuz.org/mailman/listinfo/gmsh
