tpbconv -extend ???
----- Original Message ----
From: gurpreet singh <[EMAIL PROTECTED]>
To: Discussion list for GROMACS users <gmx-users@gromacs.org>
Sent: Wednesday, July 25, 2007 6:21:06 PM
Subject: [gmx-users] problem regarding total time elapsed
Hello users
I am using gromacs 3.3 with 43a1 force field.
My question is that if i run a simulation say for 50ns , Then if i carried out
another md after this one than its time should start from ahead of 50 and not
again from the beginning. but in my case everytime the time starts from the
beginning.
I know its a very basic question which i should not ask from the intelligentsia
but this is irritating me from quiet a long time.
so please tell me if this is a usual behaviour or some mistake is there in the
input file
input file :
title = third at contant pressure equilibration
integrator = md
dt = 0.002
nsteps = 25000
nstxout = 500
nstlist = 10
ns_type = grid
pbc = xyz
coulombtype = PME
vdwtype = cut-off
Tcoupl = berendsen
pcoupl = berendsen
tau_t = 0.1 0.1 0.1
tc_grps = protein SOL CL-
ref_t = 300 300 300
ref_p = 1 1 1
tau_p = 1 1 1
compressibility = 4.5e-5 4.5e-5 4.5e-5
pcoupltype = isotropic
define = -DPOSRES
comm_mode = angular
constraints = hbonds
constraint_algorithm = shake
gen_vel = yes
gen_temp = 300
After every run i am using the output gro file as an input for the next run
Thanks & Regards
____________________________________________________________________________________
Luggage? GPS? Comic books?
Check out fitting gifts for grads at Yahoo! Search
http://search.yahoo.com/search?fr=oni_on_mail&p=graduation+gifts&cs=bz_______________________________________________
gmx-users mailing list gmx-users@gromacs.org
http://www.gromacs.org/mailman/listinfo/gmx-users
Please search the archive at http://www.gromacs.org/search before posting!
Please don't post (un)subscribe requests to the list. Use the
www interface or send it to [EMAIL PROTECTED]
Can't post? Read http://www.gromacs.org/mailing_lists/users.php
