On 24/02/2012 10:55 AM, Juliette N. wrote:
Hi all,
My average size is 2.9 nm obtained from NPT under large pressure and
now I intend to increase rc to 1.4 and rlist to 1.65 nm. I am just
worried about violating minimum image convention.
That probably violates the parametrization of your force field.
1- My question is which of rc or rlist is important for minimum image
convention?
The larger one. See manual 3.2.2.
If its rlist then I think I have to make a bigger system.
2- Will the simulation raise warning once half of the box size < rc or
(rlist) ? I mean I want to make sure than over the course of
simulation I am not breaching this rule.
Under at least some circumstances such volume changes cause fatal
errors. You can check for such after the fact with g_mindist -pi
Mark
Thanks for your guidance,
J.
--
gmx-users mailing list gmx-users@gromacs.org
http://lists.gromacs.org/mailman/listinfo/gmx-users
Please search the archive at
http://www.gromacs.org/Support/Mailing_Lists/Search before posting!
Please don't post (un)subscribe requests to the list. Use the
www interface or send it to gmx-users-requ...@gromacs.org.
Can't post? Read http://www.gromacs.org/Support/Mailing_Lists