Dear cuong nguyen.. I think use following commands. Try editconf -rotate <for rotaion angle along axis> along these use -center < co-ordinate > if you want to place canter of box at particular position
Try editconf -translate <For translation along axis > On Tue, Jul 17, 2012 at 2:07 PM, Mark Abraham <mark.abra...@anu.edu.au> wrote: > On 17/07/2012 4:32 PM, cuong nguyen wrote: >> >> Dear Gmx-users, >> >> I created a box size 4 4 2 and named layer.gro. Then "genconf" was >> used to doulble this box: >> genconf -f layer.gro -o 2layers.gro -nbox 1 1 2 -dist 0 0 8 >> However, the copied box has the same direction as the original box. >> Could you please help me to rotate 180 degrees the copied one? > > > Start with genconf -h. > > Mark > > -- > gmx-users mailing list gmx-users@gromacs.org > http://lists.gromacs.org/mailman/listinfo/gmx-users > * Only plain text messages are allowed! > * Please search the archive at > http://www.gromacs.org/Support/Mailing_Lists/Search before posting! > * Please don't post (un)subscribe requests to the list. Use the www > interface or send it to gmx-users-requ...@gromacs.org. > * Can't post? Read http://www.gromacs.org/Support/Mailing_Lists -- gmx-users mailing list gmx-users@gromacs.org http://lists.gromacs.org/mailman/listinfo/gmx-users * Only plain text messages are allowed! * Please search the archive at http://www.gromacs.org/Support/Mailing_Lists/Search before posting! * Please don't post (un)subscribe requests to the list. Use the www interface or send it to gmx-users-requ...@gromacs.org. * Can't post? Read http://www.gromacs.org/Support/Mailing_Lists
