On 11/4/13 7:14 AM, Ankita Naithani wrote:
Hi Justin,
Thank you for your reply. I did give the .tpr file but the job terminated
after few frames only. Also, if that is not helpful, do you have any
There are no frames in a .tpr file. I suspect you're simply issuing the command
incorrectly, but since you haven't shown us what you're doing, there's little
else to suggest.
suggestions to recover the essential information which you would include as
part of methods?
The .mdp file has all the instructions for the simulation. If you don't have
that around for whatever reason (very bad to get rid of such files!), all of the
same information is recorded in the beginning of the .log file or can be written
out by gmxdump. In the latter case, make sure to redirect the output to a file
rather than just have thousands of lines of text blur by in the terminal.
-Justin
--
==================================================
Justin A. Lemkul, Ph.D.
Postdoctoral Fellow
Department of Pharmaceutical Sciences
School of Pharmacy
Health Sciences Facility II, Room 601
University of Maryland, Baltimore
20 Penn St.
Baltimore, MD 21201
jalem...@outerbanks.umaryland.edu | (410) 706-7441
==================================================
--
gmx-users mailing list gmx-users@gromacs.org
http://lists.gromacs.org/mailman/listinfo/gmx-users
* Please search the archive at
http://www.gromacs.org/Support/Mailing_Lists/Search before posting!
* Please don't post (un)subscribe requests to the list. Use the
www interface or send it to gmx-users-requ...@gromacs.org.
* Can't post? Read http://www.gromacs.org/Support/Mailing_Lists
