Hi, 2009/3/8 Helena Mitasova <hmit...@unity.ncsu.edu>: > 1. It is really hard to find where to put the name of the main output > "elevation" > - it is not under tab "outputs" but it is under tab "optional" which has > several inputs > that you actually must define if you don't want to end up interpolating > category > numbers. The tab optional isn't visible, so you need to click on the arrow > to get to it. > I think the elevation should be under outputs
indeed, I am trying to keep all parameters in four tabs (which are visible by default). I don't feel familiar with v.surf.rst. Could you suggest reordering parameters to less tabs? > 2. I was unable to change the layer number - it was stuck at 1 (this may be > problem > with my installation or I am not clicking on it the right way?, typing it > in, deleting it did not > work either), so there was no way > to interpolate the z-coordinate. I think that the layer number should be It was a bug, fixed in r36250 (devbr6) and r36251 (relbr64). > P.S. Any chance for changing default layer to 0 at least in grass7, > to make it possible to run just v.surf.rst mypoints elev=myelev ? > Without defining layer, it is set to 1 and category number is interpolated > by default if column is not defined - particularly unpleasant surprise > after running a longer computation. Layer number and column name can then be > under optional. I can make the change in grass7 if there are no objections > to see whether it will cause any problems. I would suggest to replace in all modules which uses 'layer=0' with appropriate flag. Martin -- Martin Landa <landa.martin gmail.com> * http://gama.fsv.cvut.cz/~landa _______________________________________________ grass-dev mailing list grass-dev@lists.osgeo.org http://lists.osgeo.org/mailman/listinfo/grass-dev