Did you use gregorio-3.0.0-rc2-setup.exe to install gregorio? Go to this page to get more information about the command prompt:
http://windows.microsoft.com/it-it/windows/command-prompt-faq#1TC=windows-8 Select your version of windows on the right, and then click on the question "Come si accede al prompt dei comandi?" Follow the answer to that question to open a command prompt. Please reply to all so that your message goes to the list. Perhaps someone there can help you faster or better than I can. Regards, Henry On Saturday, 25 April 2015 at 08:42:12 pm +0200, Mirko Mondini wrote: > https://github.com/gregorio-project/gregorio/releases from here. > > In which command prompt i'll do this? > > _______________________ > Mondini Mirko > Via Guglielmo Marconi, 32/a > 25040 - Gianico (BS) > > 2015-04-25 19:51 GMT+02:00 Henry So Jr. <[email protected]>: > > > What is the filename of the installer you used to install Gregorio? > > What is the name of the webpage where you got the installer? > > > > Go into a command prompt and type the following: > > > > kpsewhich --var-value TEXMFLOCAL > > > > Please copy and paste the output to your reply. After typing that and > > copying the output, type the following into the same command prompt: > > > > kpsewhich gregoriotex.tex > > > > Please copy and paste the output of this command also to your reply. > > > > Please reply to all so that your message goes to the list. > > > > Regards, > > Henry > > > > On Saturday, 25 April 2015 at 07:20:04 pm +0200, Mirko Mondini wrote: > > > I'm using the last version (2.9). > > > The command of output is LuaLaTex+se > > _______________________________________________ Gregorio-users mailing list [email protected] https://mail.gna.org/listinfo/gregorio-users
