Has anyone else experienced this? I was recording a meeting last
Saturday, and on a break, I decided to change the sampling rate of
the recording function. I then started the recorder
again. Everything seemed to be functioning normally. However, I
later discovered that the second and third recordings had a
designation for the time and date, but showed "zero bytes" as the
length of the folder. I had to do a reset while holding down the #4
key to get things back to normal. Is this a normal function of how
this firmware works? Since doing this, everything seems to be
okay. I think I'll do a quick test recording whenever I do this in
the future to make sure everything's working all right. You all
might want to do the same.
Kim Lingo
If you reply to this message it will be delivered to the original sender only.
If your reply would benefit others on the list andyour message is related to GW
Micro or the BookSense, then please consider sending your message to
[email protected] so the entire list will receive it.
To manage your subscription to gw-booksense, visit:
http://www.gwmicro.com/listserv
