The settings were lost during the upgrade to add support for the new
Eloquence. Once you change them they will be remembered again.
At 10:28 AM 6/30/2008, you wrote:
Good morning. I installed the beta of WE 7 yesterday and things are
going very well. It does seem to be even more responsive on my
system than 6.1. The progress bar script is very nice. I also like
the enhanced list view script. I have noticed one small regression
from 6.1. In 6.1 the synth dialog remembere d the settings
for serial synths like my Doubletalk LT. I could switch back and
forth between software and hardware synths without making sure the
proper port was s et. Yesterday I experimented with the new
Elloquence. It worked well here. When I went back to the LT and
pressed enter there was no speech. I ran NVDA to figure out what
was up. WE put the LT on Com1 which doesn't exist on this system. I
set it back to com5 but still no speech. I closed WE and NVDA, then
restarted WE which came up talking. I hope this isn't a permanent
situation since I'm likely to switch without remembering to reset the port.
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo,
and can be searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
--
Michael D. Lawler
Voice 260-489-3671
Fax 260-489-2608
Internet mailto:[EMAIL PROTECTED]
web http://www.gwmicro.com
ftp ftp://ftp.gwmicro.com
GW Micro, Inc.,
Development Liaison and Technical Support Supervisor
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
