Hello Pam. Which synthesizer are you using?
Many thanks.
Pam Drake said the following on 9/26/2008 7:22 PM:
When I read the readme file I was delighted to read, or at least
believe I read that W/E would resume speaking after hibernation.
Unfortunately this does not appear to be the case with my new
Window-Eyes 7.0 installation. I get the familiar chime announcing that
"Window-Eyes is already running", but even if I press the space bar to
ok that message I cannot make Window-Eyes come back to life. What's
more, I can't even close W/E after launching JAWS in hopes of closing
and re-opening W/E. I'm just [plain out of luck for using Window-Eyes
unless I want to do a hard reboot. The dead Window-Eyes doesn't
interfere with JAWS, so sometimes I just stay with that for a while, but
if I want to go into hibernate or, heaven forbid, I miss the battery low
indication and the battery stops, I must re-boot to get back to
Window-Eyes.
Is there a command other than alt plus F4 I'm missing? What might be
going on here, or did I simply misunderstand the readme? <Told you I
was no good with manuals.> <sigh>
I recall much discussion of a "Kill Window-Eyes" function in the Betas,
but since I wasn't using these releases I didn't pay attention, and
didn't notice them in Script Central, though maybe I didn't read far
enough down that list.
Pam
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
--
Raul A. Gallegos -- GW Micro Technical Support
Voice: 260-489-3671 -- Fax: 260-489-2608
WEB: http://www.gwmicro.com
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
