Are you reading the table in table mode?
If so and then you try to use the find command while still in table mode the 
find command is restricted to the cell you are in. If you want to use the find 
command turn off or get out of table mode and then the find will work as you 
expect.
Shannon
  ----- Original Message ----- 
  From: Fuehrer Stacy L 
  To: [email protected] 
  Sent: Thursday, April 09, 2009 9:16 PM
  Subject: WE 7.01 the find command in a table


  Hi every one.  At work earlier today, I was on a web page, that had a table 
on it.  I could read the contents of the table without a problem, however, upon 
going to use the virtual find command to look for specific information, I was 
unable to get the cursor to the specific area where the desired information 
was, without simply arrowing through the entire table!  Does any one have 
suggestions as to how the virtual find command can be a bit more user friendly 
in a table on a web page?  
  Thank you, 
  Stacy 

If you reply to this message it will be delivered to the original
sender only.  If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.

All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be 
searched through and sorted using the search
form at the bottom of the page. 

If you wish to unsubscribe from this list, send a message to
[email protected] and include leave gw-info in the body 
of the message.


If you reply to this message it will be delivered to the original
sender only.  If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.

All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be 
searched through and sorted using the search
form at the bottom of the page.

If you wish to unsubscribe from this list, send a message to
[email protected] and include leave gw-info in the body
of the message.

Reply via email to