I'm sure this is in the manual some place. If scripting status is turned
off, the Scripting Menu is disabled, so you may have done this for some
reason or by mistake. You should make sure it is turned back on. Then you
will need to reload Window-Eyes. I tried it for myself.
----- Original Message -----
From: "Morne Van der Merwe" <[email protected]>
To: "GW Info Discussion List" <[email protected]>
Sent: Friday, January 22, 2010 3:20 AM
Subject: Concerning the script menus
\Hi list,
I downloaded the tool kit and tried to install it. I went to my
script menu in WE menu but I get the message that my script menu is
disabled. What must I do to enable the menu and how shal I know that
the tool kit is propperly installed?
Regards
--
-Morné van der Merwe
Posbus/PO Box/Posxtkesto 2036
Dennesig
Stellenbosch
7601
Suid-Afrika/South Africa/Sudafriko
Selfoon/Cell phone/Mobiltelefono: +27 (0)72-119-4488
E-pos/E mail/Retadreso:
[email protected]
Skype: mornevdm
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can
be searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, visit:
http://www.gwmicro.com/listserv
__________ Information from ESET NOD32 Antivirus, version of virus signature
database 4797 (20100122) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, visit:
http://www.gwmicro.com/listserv
